To Next Page

To Previous Page

2. INSTALLATION

2.1 REMOVAL FROM PACKAGING

The equipment is packed in durable packages designed especially for it. However, it is

necessary to check the equipment before using it to make sure that the equipment or any part

of it has not got damaged during transportation. Also check that the delivery corresponds to

your order and that you have received all necessary instructions for installing and operating

the equipment. The packaging material is recyclable.

2.2 LOCATING THE MACHINE

Place the machine on a horizontal, stable and clean ground. Protect the machine from rain

and direct sunshine. Check that there is enough space for cooling air circulation in front of and

behind the machine.

2.3 SERIAL NUMBER

Serial number of the machine is marked on the rating plate. The serial number is the only

proper means of identifying parts for a specic product. It is important to make correct

reference to the serial number of the product when making repairs or ordering spare parts.

2.4 INSTALLATION

1. Function panel

2. Remote control connector

3. TIG torch control connector, not in MMA version

4. Shield gas and current connector for TIG torch, not in MMA version

5. (+) connector for electrode holder or earth cable, in TIG welding for earth cable

6. (-) connector for earth cable or electrode holder in MMA welding (stick welding)

Markings for (+/-) poles on the machine front are embossed.

Rear of machine

7. Mains switch

8. Snap connector for gas

Kemppi Master MLS 2500 User Manual

Other manuals for Kemppi Master MLS 2500