Kemppi Minarc Evo 180 Operating Manual

EN
4.3 Storage
Store the unit in a clean and dry place. Shield it from rain, and in temperatures exceeding
+25 °C from direct exposure to sun.
4.4 Disposal of the machine
Do not dispose of electrical equipment with normal waste!
In observance of European Directive 2002/96/EC on waste electrical and electronic
equipment, and its implementation in accordance with national law, electrical equipment
that has reached the end of its life must be collected separately and taken to an appropriate
environmentally responsible recycling facility.
The owner of the equipment is obliged to deliver a decommissioned unit to a regional
collection centre, per the instructions of local authorities or a Kemppi representative. By
applying this European directive you will improve the environment and human health.
5. ORDERING CODES
Minarc Evo 180 welding machine
includes earth return and welding cables 61002180
Minarc Evo 180 welding machine (Denmark)
includes earth return and welding cables 61002180DK
Minarc Evo 180VRD welding machine
includes earth return and welding cables 61002180VRD
Minarc Evo 180AU welding machine
(Australia, New Zealand)
includes earth return and welding cables 61002180AU
Minarc Evo 140AU welding machine
(Australia, New Zealand)
includes earth return and welding cables 61002140AU
Minarc Evo 180NP welding machine
includes earth return and welding cables
(does not include mains plug)
61002180NP
Earth return cable and clamp
6184015
Welding cable and electrode holder
6184005
Carrying strap
9592163
Optional: TIG torch TTM15V
4 m 6271432
BETA 90 welding helmet
9873045
BETA 90X welding helmet
9873047
BETA 90 FreshAir with Flow Control pack
P1700
R10 hand held remote control
5 m 6185409
R10 hand held remote control
10 m 618540901
© Kemppi Oy / 1438
13

Kemppi Minarc Evo 180 Specifications

General

Input Voltage	230 V
Protection Class	IP23S
Welding Processes	MMA, TIG
Open Circuit Voltage	85 V
Electrode Sizes	1.5 - 4.0 mm
Input Frequency	50/60 Hz
Power Factor	0.99
Efficiency	82%