Kemppi PRO EVOLUTION MXE - Page 17

KEMPPI PRO EVOLUTION, MXE / 0547 – 17© KEMPPI OY
Name in
display
MIG/
MAG
1-
MIG
Pulsed
MIG
Factory
value
Explanation
Pre gas time 0-9.9 s PrEGAS X X X 0 Gas flow before welding, works
with 2T
Post gas time 0-9.9 s POStGAS X X X 1.0 Gas flow after welding
Creep start 10-99% CrEEP S X X X 50% % of wire feed speed
Hot start
-50…0…+70%
HOt-StA X X 40% % of welding power, -50% is cold
and +70% is hot
Hot start 2T (*
0....9,9 s
Hot-2tt X X 1.2 s Adjustment of Hot start time
with 2T
Spot welding (**
0.0 ... 9.9 s
SPOt-2t X X 0.0 s Spot welding in use, when Hot
start is selected and SPOt-2t is
0.1 ... 9.9 s. Welding power is
same as Hot start`s.
Creep start upslope
0…99
UPSLOPE X X X 0 Rising time to welding power,
1 is shorter, 99 is longer
Crater filling
1…99
CrAtErF X X 15 Fall time to crater slope,
1 is shorter, 99 is longer
Crater slope
0…99%
CrAtESL X X 0 End level of welding power,1%
min current, 99% max current
Start current
–9…0…+9
StArt C X X X 0 Length of start pulse
Top current
–10…+15%
top-Cur X 0 MXE-function, adjustment of
pulse current
Post current time
–99…0…+99
POStCUr X X X 0 Length of wire after stop welding
e.g. Al <0, Fe > 0
Control range of arc
length –50…0…99%
ArCLEnG X X 0 Expands arc length range (knob)
Douple pulse
amplitude
0,1 ...2,5m/min
dPULS-A X 1,5 m/min Wire feed variation in douple
pulse
Douple pulse
frequency
0,1 ... 3,0 Hz
dPULS-F X 2 Hz Frequency variation in douple
pulse
Calibration voltage
0…9.9 V
CAL X X 1.4 1.4 is for general use, position of
arc length range can be moved
within 0…9.9V
Restoring of factory
settings
rEStOrE
FAC ALL
X X X Restores factory settings to User
parametres
(* Since Promig program version 0A5
(** Since Promig program version 0A6