KEN DW 412 Section/page:12.1
Subject to alterations 17/9/2013
Trouble shooting/error codes
General comments concerning error codes
KEN microprocessor controls are able to diagnose a number of errors by the
machine installation, operation or components; errors that have already
resulted in - or are about to result in - operational failures.
In such cases the red LED on the control panel will flash, and the error
indication will appear on the display.
The control distinguishes between essential and unessential errors.
By an essential error the process is immediately discontinued at the
program stage at which the error occured.
By unessential errors the error name will not appear until the door is opened
after the program cycle has been completed.
Error codes short list
#20 WATER PRESSURE TOO LOW
#25 MISSING WATER PRESSURE
#30 SLOW HEATING WASH TANK
#31 SLOW HEATING RINSETANK
#35 NO HEATING WASH TANK
#36 NO HEATING RINSE TANK
#38 LEVEL FAULT CLEAN SENSOR
#39 LOW LEVEL MISSING
#40 MISSING RINSE AID
#50 MISSING DETERGENT
#53 CHANGE WASH WATER
#54 CHANGE WATER STRAINER
#55 DRAIN FAULT
#65 HOOD FAULT
#76 DEF. THERMOSENSOR WASH TANK
#77 DEF. THERMOSENSOR RINSE TANK
#85 HOOD SECURITY ENABLED
#86 HOOD BLOCKED
#200 INT. SW FAULT
To Next Page
Loading...