Ken DW 412 - Machine Parameters; Machine Adjustments Overview

KEN DW 412 Section/page:16.1
Subject to alterations 17/9/2013
Parameters
Adjustments of the machine
Description
Adjustments
from factory
Possible
adjustments
User adjustments
Machine Number
Type of machine DW412 DW410, DW412 This adjustment must
ALWAYS be DW412 for
this type of machine.
Language English English
Danish
German
Swedish
Norwegian
Condenser or exhaustion
This adjustment indicates whether the
machine is connected to exhaustion,
condenser or none.
Exhaustion Exhaustion
Condenser
None
Drain pump
This adjustment indicates whether the
machine is fitted with drain pump or not.
Not installed Installed
Not installed
Water change
This adjustment indicates whether water
change is done automatically or manually.
The machine must be fitted with a drain
pump to do automatically water change.
Manual Manual
Automatic
Water change interval
(Number of washes)
Indicates number of washes between each
water change. If the machine is adjusted to
do automatical water change, the machine
will empty the water tank after the selected
number of washes. If the machine is
adjusted to manual water change an alarm
will go after the selected number of washes.
00-999
Re-electing program
Re-elect of the program which the machine
runs. When the machine is turned on and
after each wash the machine will be
adjusted to this program. The operator can
then just press the start key or select
another program if needed.
No re-election Program 1
Program 2
Program 3
Program 4
No re-election
Heating wash tank effect (W)
Indicates the size of the heating element in
the wash tank. This adjustment is used for
estimating the consumption of energy and
validation of heating time, and by that
deciding if the heating element is defect.
9000 0-99999