Section/page:16.4
Parameters
KEN DW 412
Subject to alterations 17/9/2013
Program parameters
Description
Possible
adjustments
Adjustments from factory User adjustments
Prog. 1 Prog. 2
Prog. 3 Prog. 4
Prog. 1 Prog. 2 Prog. 3 Prog. 4
Program active
A program must be active to be
chosen and started.
Yes/no Yes Yes Yes Yes
Wash time (sec)
Length of the “wash phase”.
If this setting is 0, the “wash
phase” and “pause before
rinse” is skipped.
0-999 60 120 240 600
Pause before rinse (sec)
Length of the pause between
“wash phase” and “rinse
phase” in seconds.
0-999 15151515
Rinse time (sec)
Length of “rinse phase”.
0-999 12121212
Pause after rinse (sec)
Lenth of the pause after rinse
(in seconds).
0-999 15151515
Wash temperature
The wanted temperature in °C
for washing.
1-99 57 57 57 57
Min. wash temperature
The lowest tempearature in °C
a wash can be started at.
1-99 49 49 49 49
Rinse temperature
The wanted temperature in °C
for rinsing.
1-99 80 80 80 80
Detergent dosing calibration
A-B-C-DAAAA
High/Low wash pressure Low
High,
Low/High,
High/Low
Low Low Low Low
Exhaustion during... None
Wash
Rinse
Wash+Rinse
Wash+
Rinse
Wash+
Rinse
Wash+
Rinse
Wash+
Rinse
Exhaustion after rinse (sec)
Indicates number of seconds
the exhaustion must run after
the rinse phase.
0-999 300 300 300 300
Condensing after rinse (sec)
Indicates number of seconds
the condensator must run after
the rinse phase.
0-9990000
To Next Page
Loading...