CYCLE OPTIONS AND SPECIAL FEATURES
Your dryer features several additional cycle options and special features to meet your individual needs. For all steam
features, see the following pages.
WRINKLE GUARD
Selecting this option will tumble the clothes after
the cycle ends for a few seconds every few minutes
without heat. This option is active for 180 minutes after
the end of the cycle, or until the door is opened. This
helps prevent wrinkles if the clothes are not removed
immediately after the cycle has finished.
CONTROL LOCK
Use this option to disable the controls.
All controls will be disabled except for the POWER
button. Once set, the Control Lock must be turned off
before the controls can be used. After the dryer has
shut off, the POWER button will allow the dryer to be
turned on, but the controls will remain locked. When the
Control Lock is set, the LED will illuminate and "CL" will
display alternately with the cycle time.
Press and hold the Wrinkle Guard button for five
seconds to activate or deactivate the Control Lock.
MY CYCLE
MY CYCLE allows you to store a customized dry cycle for
future use. It allows you to save favorite temperature, dry
level, and other options for a cycle, and then recall
them at the touch of a button.
NOTE: You can only save the customized settings for one
cycle at a time. Pressing and holding the MY CYCLE
button will overwrite any previously saved cycle.
To save a MY CYCLE:
Press the POWER button to turn on the dryer.
O Turn the cycle selector knob to select the desired cycle.
O Pressthe CYCLE MODIFIER button to adjust the cycle as desired.
O Press the CYCLE OPTION button to add the desired options.
O Press and hold the MY CYCLE button.
DRUM LIGHT
The drum is equipped with a blue LED that illuminates
when the dryer is turned on. This light automatically
turns off when the door is closed and the cycle starts.
To turn on the light during a cycle, press and hold the
RACK DRY button for three seconds. The drum light will
illuminate and then turn off automatically after four
minutes.
INSTALLING AND USING THE DRYING RACK
With the dryer door open, slide the rack into the
dryer drum.
To recall a MY CYCLE:
O Press the POWER button to turn on the dryer.
O Pressthe MY CYCLEbutton. Thestored settings
will
be displayed.
O Press the START/PAUSE button to start the cycle.
NOTE: MY CYCLE can be adjusted the same as any
other cycle. However, once any other button is pressed,
the LED will turn off, indicating that the settings are no
longer those of your saved cycle. Press and hold the MY
CYCLE button for five seconds to overwrite the previous
MY CYCLE settings and replace them with the current
settings.
DAMP DRY SIGNAL
if you press the Damp Dry Signal, the dryer will emit a
chime when the clothes are just short of completely dry,
in case you want to remove them for ironing or hang
drying.
O
Make sure the front of the rack is seated properly in
the recess on the lint filter housing at the front of the
drum. The two rear legs of the rack should be resting
on the rear wall just above the drum.
Place items to be dried on the rack. Make sure that
no parts of the article hang over the edges of the
rack, as they might be contacted by the rotating
drum, causing noise or damage to the drum
or articles.
NOTE: Be sure to remove the drying rack after using
the RACK DRY cycle.
25
To Next Page
Loading...
