BEFORE CALLING FOR SERVICE (continued)
Display shows error Temperature sensor failure. Turn off the dryer and call for service.
code: tel or rE2
Lint on clothes Lint filter not cleaned properly.
Steam Features Not
Working
Laundry not sorted properly.
Excess static in clothes.
Dryer is overloaded.
Tissue, paper, etc. left in pockets.
Steam is not generated and no error
code is displayed.
Garments are still wrinkled at the end of
the STEAM REFRESH cycle.
Water drips down the door during
steam cycles.
Drum does not turn during steam cycles.
Remove the tint from the filter before every
load. With the lint removed, hold the filter
up to a light to see if it is dirty or clogged. If
it looks dirty, follow the cleaning instructions
in the Care and Cleaning Section. With some
loads that produce high amounts of lint, it may
be necessary to clean the filter during the cycle.
Some fabrics are lint producers (i.e., a fuzzy
white cotton towel) and should be dried
separately from clothes that are lint trappers
(i.e., a pair of black linen pants).
Use a fabric softener to reduce static
electricity. Be sure to follow the
manufacturer's instructions.
Overdrying a load of laundry can cause a
buildup of static electricity. Adjust settings
and use a shorter drying time, or use AUTO
DRY cycles.
Divide extra large loads into smaller loads for
drying.
Check pockets thoroughly before washing and
drying clothes.
Check for condensation on the inside of the
door during steam portion of the cycle. Steam
is not directly visible. This isnormal.
Check steam feeder drawer.
(1) Make sure steam feeder is filled with
water to the MAX line.
(2) Make sure steam feeder is seated
properly and drawer is fully closed.
(3) Turn the dryer off, then turn back on and
restart the steam cycle.
DO NOT USE DISTILLED WATER - The water
level sensors in the steam generator will not
work.
Steam feeder pump not working - call for
service.
Load only one to five garments (or a single
bulky item). Do not mix fabric types.
STEAM REFRESH is most effective on 70/30
cotton/polyblends. Do not use on 100% cotton
items.
Steam is invisible. However, under some
conditions, the condensed fog may be seen,
or condensation will form on the inside of the
door glass and may be seen dripping down
the glass.
The drum isturned off so that the steam vapor
remains in the drum. The drum will turn for only a
few seconds, once a minute.
33
To Next Page
Loading...
