29
SLAVE c/n supports 4 channels and 3 different groups in TTL, manual
and multi wireless modes. The SLAVE unit and the MASTER unit must
be on the same channel and group in order to work.
When in SLAVE mode, press the ‘zoom’ button twice so that the
channel number ashes, then use the left and right buttons to select
a channel (between 1-4). Once selected, press the ‘zoom’ button
again and the group letter will ash – press left and right to select a
group. Press the ‘set’ button or wait until the icon stops ashing to
conrm settings.
When in SLAVE mode, the ashgun is completely controlled by the
MASTER ash and will operate as per the information on the MASTER
ash display.
To Next Page
Loading...