Hot Water Cleaner Batch 1015-1030
Kent high pressure\Hot Water 1015-1030\Brugs-Hedvand-EN-e.237.doc
Even if the high-pressure washer has only been operated using “clean” tap water, never drink water
from the machine as the bacteria content may have increased and be left over from a previous heating.
Hot water that has passed through the high-pressure washer must not be used in connection with the
production or preparation of food as machines used in the product of foods are subject to some
extremely strict requirements.
Frost protection.
The cleaner must be stored in a frost-free environment. If this not possible, protect the pump and pump
components in the following way:
Fit one end of a short 3/4" hose to the water inflow and place the other end of the in a 5l of methylated
spirits. Start the cleaner, open the gun and close again once the methylated spirits start coming out of
the nozzles.
If the machine has been exposed to frost, never start it before it has been
completely thawed. Allow your dealer to check for any damage.
Important.
After using chemicals/soap, the injector suction hose and check valve MUST be flushed with clean
water. Place the injector suction hose in a bucket or similar vessel containing clean water, and allow the
injector to suck up water for a few minutes.
Never direct the jet towards electrical installations or living objects.
Never pull the machine by electrical cables or high pressure hoses as this may
result in the machine’s components being damaged and invalidate the warranty.
Because it is under high pressure, the water jet has a cutting effect on delicate surfaces.
Never turn the jet on yourself or towards other people or animals. Even at lower water temperatures, the
cleaner may not be used to give “baths" to animals as the water jet can cause serious damage to areas
that it comes into contact with. Sensitive areas such as the eyes and ears can suffer severe and painful
damage.
Electrical installations and live electrical cables must not pressure washed.
Stop the machine.
Shut off the water, open the gun and allow the machine to run for 15-30 seconds.
Disconnect the motor protection device.
Purge hose pressure.
Disconnect the power plug.
To Next Page
Loading...