Hot Water Cleaner Batch 1015-1030
Kent high pressure\Hot Water 1015-1030\Brugs-Hedvand-EN-e.237.doc
Specify the model and the machine number that is attached to the hot water cleaner, so that we can
deliver the ordered spare parts for your machine. Always use original spare parts.
Overleaf, you will find details of the mobile hot water cleaner, together with a product number for each
spare part. The stationary unit uses the same components, but installed in a sealed compartment
below the wheels.
Troubleshooting on Hot Water Cleaner
Hot water cleaner does
not start.
Fuse defective.
Power plug dirty.
Thermo relay disengaged.
Defective motor.
Blocked nozzle.
Replace fuse.
Cleaning of plug.
Press the reset button on the
machine.
Request an authorised technician.
Request an OR test.
1 Phase absent.
Fault in cable.
Check power plug.
Check power cord.
Oil burner does not ignite.
Flow switch hangs or is defective.
Defective thermostat.
Fault in electrical box.
Request an authorised technician.
Oil burner stops during
operation.
Immediately shut off the
machine.
(turn breaker to 0)
Drain diesel tank.
Electrodes are incorrectly set or are
dirty.
Oil nozzle blocked.
Fault in electrical system.
Machine plate / data plate
Replenish diesel oil.
Clean and adjust electrodes.
Clean nozzle.
Request an authorised technician.
Incorrect oil pressure.
Water or dirt in diesel oil.
Use only clean diesel oil.
Spiral is scaled up or the chamber is
blocked with soot/carbon deposits.
Descale the pipe system.
Clean the spiral.
Or request an authorised technician.
Circulation valve
disengages.
Incorrect nozzle.
Dirt in nozzle.
Valve on nozzle pipe defective.
Parts must be inspected and
cleaned.
Cleaner does not produce
pressure.
Water filter blocked.
Hose constricted.
Leaks on hoses.
Pump defective.
Clean the filter.
Request a technician service.
To Next Page
Loading...