Kenwood Basic M1D - Before Applying Power; Unpacking and Inspection; AC Voltage Selection

For your records ©
Record the serial number, found on the back of the
unit, in the spaces designated on the warranty card,
and in the space provided below. Refer to the model
and serial numbers whenever you call upon your dealer
for information or service on this product.
Models Serial number __
Unpacking
Unpack the unit carefully and make sure that all ac-
cessories are put aside so they will not be lost.
Examine the unit for any possibility of shipping
damage. If your unit is damaged or fails to operate,
notify your dealer immediately. If your unit was shipped
to you directly, notify the shipping company without
delay. Only the consignee (the person or company
receiving the unit) can file a claim against the carrier for
shipping damage.
We recommend that you retain the original carton and
packing materials for use should you transport or ship
the unit in the future.
WARNING:
TO PREVENT FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
Safety precaution for AC plug EOE
U.S.A. and Canada)
CAUTION: To PREVENT ELECTRIC SHOCK DO NOT
USE THIS (POLARIZED) PLUG WITH AN EXTENSION CORD,
RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN
BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
Before applying power
Important!
U.S.A., Canada, Australia and Europe
- Units shipped to the U.S.A. and Canada are designed
for operation on 120 V AC only.
Units shipped to Australia are designed for operation on
240 V AC only.
Units shipped to Europe are designed for operation on
220 V AC only.
These units are not equipped with an AC voltage selec-
tor switch and the discussion of such a switch that
follows, should be disregarded.
All other countries
Units shipped to countries other than the above coun-
tries are equipped with an AC voltage selector switch —
on the rear panel. Refer to the following paragraph for
the proper setting of this switch.
AC voltage selection
This unit operates on 120 volts or 220 - 240 volts —
AC. The AC voltage selector switch on the rear panel is
set to the voltage that prevails in the area to which the ©
unit is shipped. Before connecting the power cord to
your AC outlet, make sure that the setting position of |
this
switch
matches
your
line
voltage.
If
not,
it
must
be
set to your vonage in accordance with the following
direction.
Note:
Our warranty does not cover damage caused by excessive line
voltage due to improper setting of the AC voltage selector switch.
AC120V~ < & AC220-240V~
AC120V~\< » AC220-240V~
This shows switch
level locked in the 220-240 V~
position.
This shows switch
lever locked in the 120 V~
position.
Move switch lever to match your ~
line voltage with a small screw-
driver or other pointed tool.
AC voltage selector switch