To Next PageTo Next PageWhy does Kenwood DNX7330BT say Antenna Error?
An 'Antenna Error' on your Kenwood GPS means the antenna has a short-circuit, activating the protective circuit. Check the Digital Radio antenna. If using a passive antenna without a booster, set Antenna Power to “OFF”.
What does USB Device Error mean on Kenwood DNX7330BT?
A 'USB Device Error' on your Kenwood GPS means that the connected USB device requires more current than the allowable limit. Check the USB device; there may be an issue with it.
What to do if Kenwood GPS shows Disconnected Error?
If your Kenwood GPS displays a 'Disconnected Error', it means the iPod/Bluetooth audio player is selected as a source, but none is connected. Change the source to any option other than iPod/Bluetooth. Then, connect an iPod/Bluetooth audio player and change the source back to iPod/Bluetooth.
What to do if Kenwood GPS says No Device Error?
If your Kenwood GPS shows a 'No Device Error', it means the USB device is selected as a source, but no USB device is connected. Change the source to something other than USB/iPod. Then, connect a USB device and switch the source back to USB.
What to do if Kenwood GPS displays Hot Error?
If your Kenwood GPS displays a 'Hot Error', use the unit again after it has cooled down.
What does Error 07–67 mean on Kenwood GPS?
If your Kenwood GPS displays 'Error 07–67', it means the unit isn't operating correctly. Try pushing the unit’s Reset button. If the message persists, consult your Kenwood dealer.
What does Read Error mean on Kenwood GPS?
A 'Read Error' on your Kenwood GPS can occur for a couple of reasons: * The disc is quite dirty, so clean it. * The disc is upside down, so load the disc with the labeled side up.
What does Mecha Error mean on Kenwood DNX7330BT GPS?
A 'Mecha Error' on your Kenwood GPS indicates that the disc player is malfunctioning. Eject the disc and try inserting it again. If the error continues or the disc cannot be ejected, contact your Kenwood dealer.
Why is Kenwood DNX7330BT GPS radio reception poor?
Poor radio reception on your Kenwood GPS could be due to a couple of reasons: * The car antenna may not be fully extended, so pull it out all the way. * The antenna control wire might not be connected properly; ensure it is correctly connected.
What to do if Kenwood DNX7330BT says Protect Error Message?
If you see a 'Protect Error Message' on your Kenwood GPS, it means the protective circuit has been activated because a speaker cord has shorted or come into contact with the car chassis. You should wire or insulate the speaker cord as needed and then push the Reset button.
General