Kenwood DNX7340BT - Service Manual

This product uses Lead Free solder.
This product complies with the
RoHS directive for the European market.
© 2009-4 PRINTED IN JA PAN
B53-0720-00
(
N
)
341
DDX6034/6034M/6054
/7034BT/7034BTM/714
DNX7000EX/7140/7240BT/7340BT
MONITOR WITH DVD RECEIVER / NAVIGATION SYSTEM
SERVICE MANUAL
NAVIGATION SYSTEM
DNX7340BT
ATT AUD SRC TELNAV
VOLUME
ILLUSTRATION IS
RC-DV330
DC cord *
(E30-6881-15)
DC cord *
(E30-6796-05)
Screw set
*
(N99-1779-15)
Lever
(D10-7012-04) x2
Remote controller assy
(A70-2082-15) RC-DV330 :DNX
(A70-2083-15) RC-DV340 :DDX
Mounting hardware assy
(J22-0657-03)
Escutcheon
*
(B07-3172-12)
Size AAA battery
(Not supplied)
Cord with plug(relay) *
(E30-6786-05)
Escutcheon
(B07-3224-31)
Illustrations is DNX7340BT
ANT module(GPS-ANT)*
(W02-5305-05)
Mounting hardware*
(J21-9867-04)
Adhesive double-
coated tape
*
(H30-0595-04)
(5m)
(1m)
PRK: (2m)
REV: (5m)
The IC101,102 and IC801 in the Video control unit (X15-123/134) are not replaceable components.
When this IC are defective, replace the whole Video control unit (X15-123/134).
The IC1 in the Sub-circuit unit (X16-659) are not replaceable components.
When this IC are defective, replace the whole Sub-circuit unit (X16-659).
The IC3 and IC11 in the DVD unit (X37-1250-00) are not replaceable components.
When these ICs are defective, replace the whole DVD mechanism assembly (X92-6400-00).
You cannot replace only the board.
Cord with pinplug(AV)
(E30-6899-05)
Cord with pinplug(PRE)
(E30-6898-05)
Clamper *
(J11-0660-05)
* Depends on the models. Refer to the parts list.
Microphone *
(W01-1718-05)
(3m)