Why is voice not recognized by my Kenwood KDC-BT41U Car Receiver?
If your Kenwood Car Receiver is not recognizing your voice, it could be due to several reasons: - If the vehicle window is open, close the vehicle windows to reduce noise. - If your voice is small, speak into the microphone a little more loudly and naturally. - Only the voice of the person who registered the voice tag can be recognized.
What to do if “NA DEVICE” appears on Kenwood KDC-BT41U Car Receiver?
If the message “NA DEVICE” appears on your Kenwood Car Receiver, connect a supported USB device and check the connections. Alternatively, check that the supported SD card is inserted.
What does “HF DISCONCT” mean on my Kenwood KDC-BT41U?
If “HF DISCONCT” appears on your Kenwood Car Receiver, it means that the unit cannot communicate with the cell-phone.
How do I resolve the “iPod ERROR” on my Kenwood KDC-BT41U Car Receiver?
If your Kenwood Car Receiver displays “iPod ERROR”, try reconnecting the iPod. Also, confirm that the iPod's software is the latest version and try resetting the iPod.
What causes disc sound to be interrupted on Kenwood KDC-BT41U?
If the disc sound on your Kenwood Car Receiver is sometimes interrupted, try these steps: - Stop playback while driving on rough roads. - Change the disc. - Check the cords and connections.
Why does my Kenwood KDC-BT41U Car Receiver say “NO DISC”?
If your Kenwood Car Receiver displays “NO DISC”, it means that there is no disc in the loading slot. Insert a playable disc into the loading slot.
What to do if my Kenwood KDC-BT41U Car Receiver does not work?
If your Kenwood Car Receiver is not working at all, try resetting the unit.
Why is the radio reception poor on my Kenwood KDC-BT41U?
Poor radio reception or static noise on your Kenwood Car Receiver can be due to antenna issues. Make sure the antenna is firmly connected and fully extended.
What does “DEVICE FULL” mean on my Kenwood KDC-BT41U?
If “DEVICE FULL” appears on your Kenwood Car Receiver, 5 Bluetooth devices have already been registered and no more Bluetooth devices can be registered.
What to do if “NO DEVICE” appears on Kenwood KDC-BT41U?
If the “NO DEVICE” message appears on your Kenwood Car Receiver, connect a USB device and change the source to USB again. Alternatively, insert an SD card and change the source to SD again.
General| Brand | Kenwood |
|---|---|
| Model | KDC-BT41U |
| Category | Car Receiver |
| Language | English |
To Next Page
