Need help?Do you have a question about the Kenwood KR-5150 and is the answer not in the manual?
General| Damping Factor | 30 |
|---|---|
| Speaker Load Impedance | 4 - 16 ohms |
| Frequency Response | 20Hz to 20kHz |
| Input Sensitivity | 2.5mV (MM), 150mV (line) |
| Signal-to-Noise Ratio | 90dB (line) |
| Tuning Range | FM: 87.5 - 108 MHz, AM: 530 - 1600 kHz |
Features 2-FET front-end and 2-IC/mechanical filter IF stages for optimal reception.
Details connecting up to three speaker sets and using the front panel selector.
Instructions for connecting the AC line cord to a power outlet.
Provides advice on selecting and connecting FM antennas for best stereo reception.
Step-by-step instructions for tuning and adjusting AM and FM broadcasts.
Guide for connecting and operating record players via PHONO inputs.
Explains the protection circuit preventing damage from short circuits or overloads.
Instructions on how to safely replace the 2A fuse in the unit.
Addresses common problems like no sound, sound from one side, or noise.
Covers phono-related problems such as hum, buzz, and howling.
To Next Page
