Need help?Do you have a question about the Kenwood L-07D and is the answer not in the manual?
General| Platter Diameter | 310mm |
|---|---|
| Speeds | 33, 45rpm |
| Motor | DC Servo Motor |
| Overhang | 15 mm |
| Platter | Aluminum |
| Signal to Noise Ratio | 78 dB |
Internal view of the power supply unit with labeled components.
Step-by-step procedure for disassembling the tonearm assembly.
Instructions for the removal and replacement of the motor.
Procedure for detaching the control PCB assembly from the unit.
Logic diagram for the control switch unit.
Logic diagram for the operation unit.
Prerequisites and checks before performing adjustments.
Procedure for adjusting the Phase Locked Loop (PLL).
Adjusting offset at the beginning of operation.
Adjusting offset while the unit is playing.
To Next Page
