Kenwood NXR-1700 Function Reference

2
FUNC (E)/ Ver 2.00
4.8 Toggling the Capability to Transmit by Using the PTT (Test PTT) Control between Enabled and Disabled
(Local TX Enable/Disable) ..................................................................................................................... 88
4.9 Toggling All Transmissions by Using PTT Controls Between Enabled and Disabled (TX Enable/Disable)
............................................................................................................................................................... 89
4.10 Toggling Repeat Behaviors Between Enabled and Disabled (Repeat Enable/Disable) ......................... 89
4.11 Configuring the Threshold to Activate or Deactivate the RSSI Voltage Detection Function (Lowest Receive
Level Threshold) .................................................................................................................................... 90
4.12 Waiting to Receive on the Transmit Frequency (Standby on Transmit Frequency) ................................ 91
4.13 Operation Mode ..................................................................................................................................... 92
4.14 Take Over .............................................................................................................................................. 94
5 SOUND ......................................................................................................................................................... 95
5.1 Tones that Sound When a User Operates the Repeater or When the Repeater Status Is Changed ..... 95
5.2 Transmitting a Test Tone during Transmission (Test Tone) ..................................................................... 95
5.3 Transmitting a Courtesy Tone After Transmission Ends (Courtesy Tone) .............................................. 96
5.4 Voting Pilot Tone .................................................................................................................................... 98
6 ANALOG COMMUNICATIONS ..................................................................................................................... 99
6.1 Using Signaling ...................................................................................................................................... 99
6.2 Continuing Transmission for a Certain Length of Time After Reception Stops (Repeater Hold Time) .. 102
6.3 Temporarily Disabling the Squelch (Squelch Off) ................................................................................. 102
6.4 Adjusting the Reception Sensitivity of the Repeater (Squelch Level) ................................................... 103
6.5 Temporarily Disabling the Signaling (Monitor) ...................................................................................... 104
6.6 Avoiding Interference with Other Communications (Busy Channel Lockout (Analog)) ......................... 105
6.7 Using the Network by Using an Analog GID ........................................................................................ 106
7 DMR DIGITAL COMMUNICATIONS ........................................................................................................... 108
7.1 About Own ID ....................................................................................................................................... 108
7.2 About the Slot Number (Slot Selection) ............................................................................................... 108
7.3 Using Signaling .................................................................................................................................... 109
7.4 Avoiding Interference with Other Communications (Busy Channel Lockout (DMR)) ............................. 111
7.5 Continuing Transmission for a Certain Length of Time After Various Transmissions End .................... 113
7.6 Making a Group Call ............................................................................................................................ 117
7.7 Making an Unaddress Call ................................................................................................................... 117
7.8 Limiting the IDs for Repeat Transmission (User List (GID)/ User List (UID)) ........................................ 117
7.9 Interrupting Voice Communications from Subscriber Units Other than the Calling Subscriber Unit (Call
Interrupt) .............................................................................................................................................. 125
8 NXDN DIGITAL COMMUNICATIONS ......................................................................................................... 126
8.1 NXDN Mode ......................................................................................................................................... 126
8.2 RAN Encode/ Decode .......................................................................................................................... 128
8.3 NXIP Site ID ......................................................................................................................................... 129
8.4 Avoiding Interference with Other Communications (Busy Channel Lockout (NXDN)) .......................... 130
8.5 Radio Access Control ........................................................................................................................... 131

Kenwood NXR-1700 Specifications

General

Brand	Kenwood
Model	NXR-1700
Category	Repeater
Language	English