Kenwood PS Series User Manual

*The switches on the rear panel are used to select an remote control method
and to change over the voltage remote sensing function. They are set as
shown below in the factory:
Only switch 1 is
set ON.
2) Notes on the instalI at ion condi t ions
and load applicat ions
*The rated operation temperature of the PS Series is between 0 and 50°C.
If it is used at an extremely high ambient temperature, a built-in thermal
protector circuit functions and turns the power relay off.
*Do not use the PS Series with the air intake in the front panel and fan port
in the rear panel blocked. Keep a clearance of 30 cm or more between either
port and an object next to it. Do not allow hot air to enter into the
unit through the air intake in the front panel.
*Do not use the PS Series in a place subject to dust, corrosive gas, etc.
*The PS Sereis is a switching type power supply unit. Note that it may
have bad influences upon highly sensitive measuring instruments placed on or
beside it or connected with the same AC power line that the PS Series is
connected with.
*The PS Series is a switching type power supply unit. Do not use it in the
places or for applications shown below:
1. Use in an EMI measuring site or a shielded room
2. Use in an adjustment and inspection line of receivers, tuners, etc.
3. Use for loads affected by switching noises or ripples in the AC line
13

Kenwood PS Series Specifications

General

Category	Power Supply
Manufacturer	Kenwood
Input Frequency	50/60 Hz
Dimensions	Varies by model
Weight	Varies by model
Output Voltage	Adjustable
Line Regulation	≤0.01% + 3mV
Load Regulation	≤ 0.01% + 3 mV
Ripple and Noise	≤1mVrms
Display	Digital LED
Model	PS Series
Protection	overvoltage, overtemperature
Input Voltage	100/110/120/220/230/240 VAC (depending on the model and region)