Kenwood PS Series User Manual

Jl
J.
Deactivate the switch.
Activate the switch again.
Only the decimal points are displayed.
6-22 Resetting Alarm Condition
If some error occurs in the PS Series while it is running, the ALARM LED © on
the front panel goes on, and operation of the PS Series is disabled.
In such a case, deactivate the POWER switch ® on the front panel (switch
released), make sure that the ALARM LED goes off, then activate the POWER
switch again (switch depressed). The PS Series is recovered from the alarm
id becomes ready for operation in approx. four seconds.
NOTE: If the ALARM LED remains lighting after activating the POWER switch
again (switch depressed), the PS Series may be defective.

Kenwood PS Series Specifications

General

Category	Power Supply
Manufacturer	Kenwood
Input Frequency	50/60 Hz
Dimensions	Varies by model
Weight	Varies by model
Output Voltage	Adjustable
Line Regulation	≤0.01% + 3mV
Load Regulation	≤ 0.01% + 3 mV
Ripple and Noise	≤1mVrms
Display	Digital LED
Model	PS Series
Protection	overvoltage, overtemperature
Input Voltage	100/110/120/220/230/240 VAC (depending on the model and region)