Kenwood TKR-751 Service Manual

Document Copyrights
Copyright 2006 by Kenwood Corporation. All rights reserved.
No part of this manual may be reproduced, translated, distributed, or transmitted in any
form or by any means, electronic, mechanical, photocopying, recording, or otherwise, for
any purpose without the prior written permission of Kenwood.
Disclaimer
While every precaution has been taken in the preparation of this manual, Kenwood
assumes no responsibility for errors or omissions. Neither is any liability assumed for
damages resulting from the use of the information contained herein. Kenwood reserves
the right to make changes to any products herein at any time for improvement purposes.

Kenwood TKR-751 Specifications

General

Brand	Kenwood
Model	TKR-751
Category	Repeater
Language	English

Summary

Modification Procedures

Single Antenna Configuration

Details on using the TKR-751 as a base station by sharing an external antenna connector.

Antenna Modification Steps

Instructions for modifying the final unit for single antenna configuration by repositioning components.

Coaxial Cable Connection

Procedure for connecting a coaxial cable to the final unit for single antenna setup.

FPU Simplex Channel Setting

Guidance on setting the channel to 'Simplex' using the FPU for single antenna operation.

Parts List

Exploded View

PC Board Layouts

Component Side PC Board

Detailed layout of the PC board's component side, showing placement of electronic components.

Foil Side PC Board

Detailed layout of the PC board's foil (solder) side, showing copper traces and connections.

Schematic Diagrams