EasyManuals Logo

Kenwood TS-850S Replacement Manual

Kenwood TS-850S
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
TS-850S REPLACEMENT OF D31 AND D4-D5-D6
copyright 2005 B&B Technical Services. All rights reserved. May be reproduced for personal use only. We are not responsible for loss
or damage due to the use or misuse of this information.
Symptoms:
D31 FAILED: No or low receive and/or transmit. High pitched tone in speaker. RXB showing
more than 0 volts in transmit or TXB showing more than 0 volts in receive.
D4, D5 AND/OR D6 FAILED: “Suck out” of RX signal and or TX output on one or more
bands.
Fix: Replace affected components on opposite side of RF unit board. These are all type RLS-135
diode. No substitutes are recommended.
Remove power cable and covers of rig. Invert rig. Remove the shiny cover near the rear of the
RF unit (left hand board as rig faces you). Remove the flex connectors on the side of the board
leading to the IF unit. Remove other coax connectors as needed; MARK THEM to ensure that
they go back in the right places. You should be able to fold the board toward you and then to the
right side of the rig to work on the back side of the board.
Refer to Fig. 1 for location and orientation of the board.
Fig. 1 LOCATION OF
RF UNIT
RF unit is on the left side
of the bottom of the rig
as it faces you.
FIG. 2 LOCATION
OF D31 ON RF
UNIT
Next, using Fig. 2, located D31.
Using a GROUNDED temperature-
controlled soldering iron and some
de-soldering wick, remove the solder
from both ends of the diode. With the

Other manuals for Kenwood TS-850S

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kenwood TS-850S and is the answer not in the manual?

Kenwood TS-850S Specifications

General IconGeneral
Frequency Range (Receive)0.1-30 MHz
Antenna Impedance50 ohms
Power Supply13.8 V DC ±15%
IF RejectionMore than 80 dB
ModeSSB, CW, AM, FM
Receiver TypeSuperheterodyne
Current Drain (Transmit)20 A
Image RejectionMore than 70 dB

Related product manuals