Kenwood TS-B2000 User Manual (English)

Other manuals for Kenwood TS-B2000

Instruction Manual152 pages

Operation Procedure3 pages

Service Manual Supplement97 pages

Questions and Answers:

J
Joseph PageAug 28, 2025
What to do if Kenwood TS-B2000 no signals are received?
- B
  Brent PooleAug 29, 2025
  If no signals are received or receive sensitivity seems poor, check the following: * Ensure the SQL control is not fully clockwise; turn it counterclockwise. * Verify the Attenuator function is OFF by pressing [ATT]. * Make sure [SEND] is not pressed, which puts the transceiver in transmit mode; press [SEND] to return to receive mode. * Release Mic [PTT]. * Press [ANT] to select the other antenna connector. * Press [PRE-AMP] to switch ON function.
S
Samantha GarciaAug 28, 2025
Why Kenwood TS-B2000 Transceiver does not respond correctly after pressing button?
- K
  Keith BoydAug 28, 2025
  The issue could be due to several reasons. First, ensure procedures are followed precisely. Second, check if the Frequency Lock function is ON and, if so, press [F.LOCK] to switch it OFF. Third, the microprocessor and its memory may need resetting; consider a Partial Reset or a Full Reset. Lastly, the buttons on the transceiver are unavailable while operating the Tuning control, so stop operating the Tuning control, then press the appropriate buttons.
V
Victoria HamptonAug 27, 2025
What to do if Kenwood Transceiver has low transmit power?
- O
  ostevensAug 27, 2025
  If your transceiver has low transmit power, first, if you are in SSB or AM mode, increase the microphone gain. Second, check antenna connections to confirm that the antenna tuner is reporting a low SWR, as poor antenna system connections can cause high SWR.
N
nellisAug 26, 2025
What to do if Kenwood Transceiver received signals are totally unintelligible?
- D
  David WilliamsAug 27, 2025
  If received signals are unintelligible, the wrong modulation mode may be selected. Press [LSB/USB], [CW/FSK], or [FM/AM] to select the correct modulation mode.
N
nbrockAug 25, 2025
What to do if Kenwood TS-B2000 will not power up?
- M
  Mr. James WallaceAug 26, 2025
  First, ensure the DC power supply is switched ON. Inspect the power cable, confirming correct polarities (Red: positive (+); Black: negative (–)). Check that the connections to the DC power supply are secure. Finally, check the power cable fuse. If it's open, find the cause, correct any issues, and install a new fuse of the specified rating.
K
Kaitlyn SampsonAug 25, 2025
How to unlock frequency on Kenwood Car Receiver?
- K
  Kevin RodriguezAug 25, 2025
  If the frequency cannot be changed on your Kenwood Car Receiver, the Frequency Lock function or Lock All function may be ON. To resolve this, press [FUNC],[F LOCK] to switch the Frequency Lock function OFF. Alternatively, press [FUNC],[LOCK A] to switch the Lock All function OFF.