KERN EOB Operation Instructions

EOB/EOE/EOS/BOBP-BA-e-0620
16
7.2 Installation
Install the balance in such a fashion that the weighing plate is absolutely horizontal.
7.2.1 Unpacking the Balance
Carefully remove the balance from the packaging and out of the plastic covering,
then place the balance on the assigned position.
7.2.2 Package volume
Serial fittings:
KERN EOB
• Platform (stainless steel weighing plate) and display device
• 4 x Adjusting feet (except platform 310 x 300)
• Mains device
• Wall bracket (with anchoring screws
• Operating instructions
KERN EOE
• Platform and display device
• 4 x Adjusting feet
• Mains device
• Wall bracket (with anchoring screws
• Operating instructions
KERN EOS
• Platform (stainless steel weighing plate) and display device
• 4 x Adjusting feet
• Mains device
• Rubber mat
• Wall bracket (with anchoring screws)
• Operating instructions
KERN BOBP
• Platform and display device
• 4 x Adjusting feet
• Mains device
• Wall bracket (with anchoring screws
• Operating instructions

KERN EOB Specifications

General

Interface	RS-232
Calibration	External calibration
Weighing range [Max]	6 kg
Permissible ambient temperature	5 °C/35 °C
Material	Plastic
Readability	0.1 g
Reproducibility	0.1 g