EOC-BA-e-1920 31
Press
and the current setting for the acoustic signal
will be shown.
Select desired setting (no, ok, ng) by .
Confirm input by .
Press ; weighing system is in tolerance weighing
mode. From here evaluation takes place whether the load
is within the two tolerance limits.
Weighing with tolerance range:
Tare when using a weighing container.
Put on load, tolerance control is started. The symbols
show whether the load is within the two
tolerance limits.
Load below specified
tolerance
Load within specified
tolerance
Load exceeds specified
tolerance
• The tolerance control is not active when the weight is under 20d.
• To delete limits, enter “00.000 kg“.
To Next Page
Loading...
