KERN EOC User Manual

EOC-BA-e-1920 51
11 Instant help
In case of an error in the program process, briefly turn off the balance and disconnect
from power supply. The weighing process must then be restarted from the beginning.
Help:
Fault Possible cause
The displayed weight does not glow.
• The balance is not switched on.
• The mains supply connection has been
interrupted (mains cable not plugged
in/faulty).
• Power supply interrupted.
• (Rechargeable) batteries are inserted
incorrectly or empty
• No (rechargeable) batteries inserted
The displayed weight is permanently
• Draught/air movement
changing
• Table/floor vibrations
• Weighing pan has contact with other
objects.
• Electromagnetic fields / static charging
(choose different location/switch off
interfering device if possible)
The weighing value is obviously
• The display of the balance is not at zero
wrong
• Adjustment is no longer correct.
• Great fluctuations in temperature.
• The balance is on an uneven surface.
• Electromagnetic fields / static charging
(choose different location/switch off
interfering device if possible)
Should other error messages occur, switch balance off and then on again. If the error
message remains inform your specialist dealer.

KERN EOC Specifications

General

Brand	KERN
Model	EOC
Category	Scales
Language	English

Summary

Technical Data Specifications

General Information and Usage Guidelines

Proper Balance Usage

Describes the intended and correct method for operating the balance for accurate weighing.

Improper Use and Restrictions

Outlines incorrect operational practices that could damage the balance or yield inaccurate results.

Essential Safety Precautions

Adhering to Operation Manual Instructions

Emphasizes the importance of carefully reading the manual before operation and setup.

Qualified Personnel Operation

States that only trained personnel should operate and maintain the appliance.

Unpacking, Setup, and Commissioning Guide

Optimal Installation Site Selection

Details factors for choosing the best location for accurate and fast weighing operations.

Mains Power Connection

Initial Balance Commissioning

Balance Calibration Procedure

Detailed Adjustment Process

Linearization for Improved Accuracy

Operating the Balance

Balance Start-up Procedure

Instructions for powering on the balance and preparing it for weighing.

Zeroing the Balance Scale

Details how to reset the balance to zero using the automatic zero setting function.

Performing Simple Weighing

Weighing Operations with Tare Function

Weighing with Tolerance Limits

Tolerance Check for Target Weight

Tolerance Check for Target Quantity

Performing Parts Counting

Percentage Weighing Function

Calibration and Linearization Settings

Balance Error Messages and Descriptions

Instant Help for Common Faults