KERN EOC - Menu Overview

EOC-BA-e-1920 43
8.2 Menu overview
Menu block
Main menu
Menu item
Submenu
Available settings / explanation
PO CHK
Weighing with
tolerance range,
see chap. 7.8
nEt H Upper limit value „Tolerance check weighing“,
input see chap. 7.8.1
nEt L Lower limit value „Tolerance check weighing“,
input see chap. 7.8.1
PCS H
Upper limit value „Tolerance check counting“,
input see chap. 7.8.2
PCS L
Lower limit value „Tolerance check counting“,
input see chap. 7.8.2
BEEP no
Acoustic signal for weighing with tolerance range
switched off
ok Audio sound when load is within tolerance limits
nG
Audio sound when load is beyond tolerance
limits
P1 rEF
Zero point settings
A2n0 Automatic zero point correction (Autozero) by changing the
display, digits selectable (0.5d, 1d, 2d, 4d)
0AUto Zero setting range
Load range where the display after switching-on the balance
is set to zero. Selectable 0, 2, 5, 10, 20, 30, 50, 100 %
0rAGE Zero setting range
Load range where the display is set to zero by pressing
.
Selectable 0, 2, 4, 10, 20* , 50, 100%.
0tArE Automatic taring „on / off“, taring range adjustable in menu
item „0Auto“.
P2 COM
Interface
parameters
MODE
CONT
S0 off
Continuous data output,
selectable „sending 0“, yes / no
S0 on
ST1
One output for stable weighing value
STC
Continuous data output of stable weighing values
PR1
Output after pressing
PR2
Manual totalizing, see chap. 7.9.
Press and the weighing value will be
added to the summation memory and issued.