TEWJ-B-BA-e-2310 47
Procedure:
1. Define target quantity and tolerances
Make sure that the scale is in counting mode and that
an average piece weight has been defined (see chap.
12.2.1).
Use the navigation keys to select the setting <
target > and confirm with [ ] button.
< value > is displayed.
Confirm on [ ] button, the numeric input window ap-
pears. The active digit is flashing.
Enter the target quantity (numerical input see chap.
3.2.2) and confirm the entry.
The balance returns to the < value > menu.
Use the navigation keys to select the setting < Er-
rupp> and confirm on [ ] button.
Use the navigation keys to select the weighing unit
and confirm on [ ] button.
The numeric input window appears. The active digit is
flashing.
Enter the upper tolerance (for numerical input see
chap. 3.2.2) and confirm the entry.
To Next Page
Loading...
Need help?
General
