770/GS/GJ-BA-defsi-0023 113
5.2 Data Printout/Record for Application Programs (e.g. Counting)
For application programs, reference data (parameters) can be included in the
printout/record.
Automatic output of the reference data (parameters) Code
Off 7 1 1*
Reference quantity and reference weight 7 1 2
To have a data record printed out, perform the following:
- Press
F
to output the printout heading and reference data (the reference data will be
stored at the same time)
or
- Press
PRINT
to output the printout heading and the first value.
If you input and store new reference values while an ISO/GLP-compliant record is being
printed out, the new reference data will be output.
If you enter different data before generation of an ISO/GLP record has started, the
printout heading and the reference data will automatically be printed once you press
PRINT
. Then the measured value will be output.
- Press
PRINT
to output weighing data
- Press
CF
to end printout generation (generation of an ISO/GLP printout also ends
once an adjusting or linearisation operation has been started)
- Then press
CF
to clear the reference data for the application programs
Th printout can consist of the following lines:
-----------------
Model 770
: Balance model
S/N 040500046
: Serial number of the balance
Id
: Space for entering a workstation or operator ID
-----------------
Date 30-May-94
: Current date
Start: 10:05:30
: Start of application
Ser. :
: Space for entering a project number
nRef + 10 pcs
: Reference data (in this case, “counting - see also part 3)
wRef + 0.13400 g
Qnt + 500 pcs
: Measured values (in this case, “calculated piece count“)
:
:
End : 10:05:45
: End of application
Name :
: Space for signature of operator responsible
-----------------
To Next Page
Loading...
Need help?
General
