KERN KDP 3000-2 - Page 17

17 KDP-BA_IA-e-1710
Important:
In the standard configuration COM1 is selected as the interface. Please adjust this on
your balance. For access through Ethernet, WLAN or Bluetooth, please enter the
relevant port in the software.
For details on changing the configuration please refer to the instructions for the
BalanceConnection software.
In the example configuration the weighing platform sends data constantly.
The weight values would normally all be forwarded to the output methods.
If you only want to keep the
current value, then please use the operation "Save
value" to accept the value. In the output method, the package type must be set
to manual trigger.