PES/PEJ-BA-e-1316
7. Place sample for the first limiting val-
ue on the weighing plate:
An acoustic signal sounds, the saved
lower difference value is briefly dis-
played.
The flashing display (last saved value)
prompts you to enter the upper limiting
value
9. Place sample for the upper (i.e. larg-
er) limiting value on the weighing
plate:
10. Save
Remove sample from weighing plate.
The balance returns to tolerance weigh-
ing mode.
From here evaluation takes place
whether the goods to be weighed are
within the two tolerance limits.
An acoustic signal sounds, the saved
upper difference value is briefly dis-
played.
* If you want to set for your tolerance weighing only one limit point
(parameter selection [ ]), the input herewith is finished.
To Next Page
Loading...
Need help?
General
