Keurig B200 Use & Care Guide

12
SECTION 2
CLEANING & MAINTENANCE
Cleaning & Sanitizing the
Entrance Needle Area
Regular cleaning of the Brewer’s external
components is recommended. The needle,
entrance needle gasket, and surrounding
puncture mechanism should be wiped clean
using a clean cloth. See figure below. After
wiping the aforementioned areas clean then do
three (3) sanitizing brews. A sanitizing or
cleansing brew is performed by simply running
a brew cycle without a K-Cup in place. To do a
cleansing brew, at the ‘READY - CHOOSE K-
CUP - LIFT HANDLE’ prompt, raise the handle
and then lower it as if a K-Cup has been placed
in the holder. Press the 8oz (largest size) brew
button; repeat twice more to complete the
sanitizing process.
Cleaning the K-Cup
®
Portion Pack
Holder Assembly
1. Cleaning the Parts
The K-Cup
®
Holder Assembly (Fig. 9) is dish-
washer safe. To remove from the Brewer, open
the cover by lifting the Handle. Grasp the top of
the K-Cup
®
Holder with one hand while pushing
up on the bottom of the K-Cup
®
Holder from
underneath with the other until it releases. After
cleaning, align the K-Cup
®
Holder with the
opening using the two front ribs as a guide and
snap into place from the top.
2. Cleaning the Funnel
The Funnel can be removed from the K-Cup
®
Holder by pulling on it until it snaps off. The
Funnel is dishwasher safe. To replace it just snap
it back onto the K-Cup
®
Holder Assembly.
3. Cleaning the Exit Needle
The Exit Needle is located on the inside bottom
of the K-Cup
®
Holder Assembly. Should a clog
arise due to coffee grinds, it can be cleaned
using a paper clip or similar tool. Remove
K-Cup
®
Holder, insert the paper clip into the
Needle to loosen the clog and push it out. The
K-Cup
®
Holder is dishwasher safe.
NOTE: The Entrance needle does not require
cleaning
K-Cup Holder
Assembly
K-Cup Holder
Funnel
CAUTION: There are sharp needles that
puncture the K-Cup
®
above the K-Cup Holder
and in the bottom of the K-Cup Holder. T
o
avoid risk of injury, do not put your fingers in
the K-Cup Chamber.
Fig. 9
A. ENTRANCE NEEDLE GASKET
B. ENTRANCE NEEDLE
C. NEEDLE SURROUND SURFACE
A
B
C

Keurig B200 Specifications

General

Brand	Keurig
Model	B200
Category	Coffee Maker
Language	English