EN
4
combined with other devices;
the product may not be used until the automation
system “commissioning” procedure has been per-
formed as specied in the “Automation system te-
sting and commissioning” section;
the system power supply line must include a circuit
breaker device with a contact gap allowing com-
plete disconnection in the conditions specied by
class III overvoltage;
use unions with IP55 or higher protection when
connecting hoses, pipes or cable glands;
the electrical system upstream of the automation
system must comply with the relevant regulations
and be constructed to good workmanship stan-
dards;
this appliance can be used by children aged from 8
years and above and persons with reduced physi-
cal, sensory or mental capabilities or lack of ex-
perience and knowledge if they have been given
supervision or instruction concerning use of the
appliance in a safe way and understand the ha-
zards involved;
before starting the automation system, ensure that
there is no-one in the immediate vicinity;
before proceeding with any cleaning or mainte-
nance work on the automation system, disconnect
it from the electrical mains;
special care must be taken to avoid crushing
between the part operated by the automation sy-
stem and any xed parts around it;
children must be supervised to ensure that they do
not play with the equipment;
drive is not to be used with doors having openings
exceeding 50mm in diameter or having edges or
protruding parts a person could grip or stand on;
that the drive cannot be used with a driven part
incorporating a wicket door unless the drive can
only be operated with the wicket door in the safe
position;
in the case of detection of an obstacle during its
closing travel, the garage door reverses its travel
direction, releasing the obstacle until it opens com-
pletely;
install the actuating member for the manual rele-
ase at a height less than 1,8m. If removable, the
actuating member should be stored in direct vicini-
ty of the door;
install any xed control at a height of at least 1,5m
and within sight of the door but away from moving
parts;
permanently x the labels warning against en-
trapment in a prominent place or near any xed
controls (Fig. 1 Pag. 54);
after installation, ensure that the mechanism is
properly adjusted and that the drive reverses or
the object can be freed when the door contacts a
50mm high object placed on the oor (for drives
incorporating an entrapment protection system de-
pending on contact with the bottom edge of the
door);
after installation, ensure that parts of the door do
not extend over public footpaths or roads;
when the appliance is provided with a separa-
te stop button, that stop button shall be unambi-
guously identiable.
Frequently examine the installation for imba-
lance where applicable and signs of wear or
damage to cables, springs and mounting. Do
not use if repair or adjustment is necessary.
The automation system component packaging
material must be disposed of in full observan-
ce of current local waste disposal legislation.
Key Automation reserves the right to amend
these instructions if necessary; they and/or
any more recent versions are available at www.
keyautomation.it.
ATTENTION !
ATTENTION !
To Next Page
Loading...
Need help?
General
