◆Power-on Password Settings
Password Set represents power-on password settings. The default password is
1212. When the screen shows P2:0000, you need to input the current password or the
default password”1212”.
Press UP/DOWN to change the numbers and press ON/OFF to confirm digits one by
one until the correct 4-digit password is completed. Then press ON/OFF to access
power-on password enable settings interface; otherwise stay still in the password input
state.
Password Input Interface
Power-on Password Enable/Disable
Press the UP or DOWN button to choose Disable or Enable and press the ON/OFF
button to confirm. The default value is Disable. If you choose Enable, press the ON/OFF
button to enter Power-on Password Change interface; otherwise you will exit the power-
on password settings.
Power-on Password Disable/Enable Interface
Power-on Password Change
When the display shows “Password Set, P3:0000”, press the UP or DOWN button to
change the numbers and then press the ON/OFF button to confirm digits one by one until
a new 4-digit password is completed.
To store a new power-on password, hold the ON/OFF button for 2 seconds and
then exit settings.
When you switch on the E-bike system next time, the display will show P1,0000,
please input the new password to power on.
Power-on
Password Change
Interface
To Next Page
Loading...
