Need help?Do you have a question about the Key-Disp KD718 and is the answer not in the manual?
General| Brand | Key-Disp |
|---|---|
| Model | KD718 |
| Category | Bicycle Accessories |
| Language | English |
Shows the physical dimensions and appearance of the eBike display unit.
Shows the physical dimensions and appearance of the eBike remote control.
Instructions for powering the eBike display system on and off using the power button.
Explains how to navigate and view information on the eBike display interface.
Details how to activate and deactivate the push-assistance function on the eBike.
Instructions for controlling the eBike's lighting system via the display.
How to adjust motor assistance levels and understand power output indicators.
Explains the meaning of the battery state of charge (SOC) indicator bars.
How to read the motor's output power as displayed on the eBike screen.
Shows the display interface when connected to a USB external device.
Details how error codes are displayed and what they signify for the eBike system.
Configure display for different wheel sizes for accurate speed readings.
How to set and adjust the maximum speed limit for the eBike system.
Instructions for adjusting the brightness level of the display backlight.
Configure voltage values for the battery power bar display.
Overview of advanced settings related to Pedal Assist System (PAS) parameters.
Configuration for the speed sensor, including the number of magnets.
Settings for the number of magnets on the PAS disk for power assist.
How to choose assist level modes and configure assist ratios.
How to adjust the controller's over-current cut settings for the motor.
Adjusting the sensitivity of the power assist sensor based on magnet passage.
Configuring the slow start-up duration before power assistance engages.
Options for displaying battery State of Charge (SOC) in percent or voltage.
How to set the automatic shutdown time for the display.
How to switch between metric (km) and imperial (miles) units for display.
Overview of the password settings for powering on the display.
Instructions to enable or disable the power-on password feature.
Steps to reset the power-on password for the eBike display.
How to clear the trip distance data recorded by the display.
Illustrates the standard wiring connections for the display and controller.
Provides important cautionary notes for using the eBike display.
A list defining common error codes and their meanings for the eBike system.
To Next Page
