Key-Disp KD58C - E-bike System Operation; Basic Operations; Assist Level Management

3
Display indication cycle interface
◆Switching Push-assistance Mode On/Off
To activate the push-assistance function, press and hold the DOWN button. After 2
seconds, the E-bike will go on at a uniform speed of 6 Km/h and “P” is shown on the
screen at the same time. The push-assistance function is switched off as soon as you
release the DOWN button.
Push-assistance Mode
■Push-assistance function may only be used when pushing the E-bike. Be
aware of danger of injury when the wheels of E-bike do not have ground contact
while using push-assistance function.
◆
Switching the Lighting On/Off
To switch on E-bike lights, hold the UP button for 2s. The E-bike lights will be
switched on while display backlight darkens.
Likewise, hold the UP button for 2s again, the E-bike front light will be switched off
while display backlight recovers the brightness.
■If E-bike lights are independent of “UP” button, the “UP” button can only be used to
switch on/off the display backlight.
Switch the Lighting on/off
◆
assist Level options
Assist levels indicate the output power of the motor. The default value is level “1”.
The default power ranges from level “0” to level “5”.The output power is zero on
Level “0”. Level “1” is the minimum power. Level “5” is the maximum power.
Press UP/DOW to change the assist level.