Keyscan NETCOM2P - 1 Channel 1 (Keyscan Values)

To Next Page

To Previous Page

Keyscan Inc. A Member of the Kaba Group

11. After completing the Server parameters, press 1 for Channel 1 setup parameters and

enter the following Keyscan values. Press the Enter key after each entry.

1 Channel 1 (Keyscan Values)

 Baudrate = 9600 (Must match ACU settings)

 I/F Mode = 4C

 Flow = 00

 Port No. = 3001

 ConnectMode = C0

 Send ‘+++’ in Modem Mode = N

 Show IP addr after ‘RING’ = N

 Remote IP Address = 000.000.000.000

 Remote Port = 0

 DisConnMode = 00

 FlushMode = 80

 Pack Cntrl = 01

 DisConnTime = 15:00

 SendChar 1 = 00

 SendChar 2 = 00

12. After completing the Channel 1 parameters, Press 9 to save the configuration and

restart the NETCOM2P unit.

Note

To exit without saving any changes, press 8.