Installation Steps ...cont’d
26. Wait for the Ping Status result message:
IP Success indicates the NETCOM2P has network communication
IP Timed Out indicates the NETCOM2P does not have network communication—
verify settings and connections
27. Click on the x in the upper right corner of the Keyscan NETCOM Utility screen to close
the application.
28. Depending on the type of installation do one of the following steps:
If this is a new installation, install the Keyscan software, set up the site, and
perform a full panel upload.
If this is an existing installation, log on to a Client software module, edit the site
setup screens and perform a panel upload.
To Next Page
Loading...