Demonstration
To source a waveform without monitoring it, perform the following procedure to execute only
a Transient (Source) Action.
1) If you are not on the top Function menu, press repeatedly until you are back at
the top level.
2) Press , , , and then press to start sourcing the continuous
arbitrary waveform.
At the top level of the Function menu
No tree structure is visible
A tree structure is visible
At a lower level in the Function menu
(1) Press Trigger
(2) Press Initiate
(3) Press Trans.
(4) Press Ch 1
LAB3: Sourcing current/voltage sinusoid waveform without monitoring
Objective
Some applications do not require
monitoring of the current/voltage
sinusoid waveform being outputted.
This demo shows how to source
waveforms without monitoring the
voltage or current.
17 | Keysight | Sourcing Precise Current/Voltage Sinusoidal Waveforms Using the B2961A/62A – Demo Guide
To Next Page
Loading...
