Figure 1. Connection diagram and basic condition
Concept
Figure 1 illustrates the connection diagram and basic setup conditions used in the
demo to source current/voltage sinusoidal waveforms using the B2961A/62A. The
B2961A/62A will source a sinusoidal waveform using the settings shown below while
the output is monitored using an oscilloscope.
Figure 2 shows the parameters used to dene a sinusoid waveform from the instrument’s
front panel. Once these parameters have been specied, the specied source value is
output immediately after pressing
. Next, after you press the instrument will
source a sinusoid waveform.
Although the guide shows how to source a sinusoid waveform in voltage source mode,
by selecting current source mode you can also source a current sinusoid waveform very
easily and accurately.
B2961A/62A
Figure 2. Sinusoid waveform parameters
Output ON
Source
Value
Output
Off State
V or I
Time
Offset
Press Trigger
V
A
V
A
f
: Amplitude
: Frequency
1/f 1/f 1/f
V
A
04 | Keysight | Sourcing Precise Current/Voltage Sinusoidal Waveforms Using the B2961A/62A – Demo Guide
To Next Page
Loading...
