Keysight Technologies E4412A - Page 49

49 pages

To Previous Page

To Previous Page

Loading...

This information is subject to change

without notice. Always refer to the

Keysight website for the latest

revision.

© Keysight Technologies 1999 - 2019

Edition 9, September 4, 2019

Printed in Malaysia

*E4412-90013*

E4412-90013

www.keysight.com

Table of Contents

Safety Information2
Declaration of Conformity2
Certification3
General Warranty3
Warranty Service3
Limitation of Warranty4
Exclusive Remedies4
Safety Summary5
Safety Notices5
Safety Symbols6
Environmental Conditions7
Regulatory Markings8
General Safety Information9
Waste Electrical and Electronic Equipment (WEEE) Directivel10
- Product Category10
Sales and Technical Support10
- Table of Contents11
- List of Tables15
Operation and Service Guide19
General Information19
- Warranty19
- Instruments Covered by Manual19
- Description19
- Specifications20
- Calibration Factor (CF) and Reflection Coefficient (Rho)22
- E4412A Maximum Calibration Factor Uncertainty at Calibrated Powers22
- Installation23
- E4413A Maximum Calibration Factor Uncertainty at Cali23
- Initial Inspection23
- Interconnections24
- Recommended Calibration Interval24
- Storage and Shipment24
- Operation25
- Power Meter Calibrations26
- Adapter Test Procedure27
- Equipment List27
- Typical Specifications27
- Operating Instructions29
Performance Test30
- Standing Wave Ratio (SWR) and Reflection Coefficient (Rho) Performance Test30
- Power Sensor SWR and Reflection Coefficient for the30
- Power Sensor SWR and Reflection Coefficient for the E4413A [A]30
- Zero Set Performance Verification31
Replaceable Parts33
- Figure 1-7 Illustrated Parts Break down34
- Replaceable Parts35
Service36
- Principles of Operation36
- Troubleshooting37
- Repair of Defective Sensor37
- Connector Maintenance38
- Cleaning39
- Disassembly Procedure40
- Reassembly Procedure40
Adjustments41
- E4412A and E4413A Specifications43
- Us3848/Myxxxxxxxx/Sgxxxxxxxx)46
- E4412A Calibration Factor Uncertainty at 1 Mw (0 Dbm)46
- E4413A Calibration Factor Uncertainty at 1 Mw (0 Dbm) (Serial Prefixes below Us3848/Myxxxxxxxx/Sgxxxxxxxx)47

Related product manuals

Keysight Technologies EL33133A

Keysight Technologies EL34143A

Keysight Technologies EL34243A

Preview: EL30000 Series

Preview: U2000 Series

Keysight Technologies U2004A