11 Keysight M9037A PXIe Embedded Controller Startup Guide
Step 2: Verify Shipment Contents
Step 2: Verify Shipment Contents
Your shipment should have included the following:
- The Keysight M9037A Embedded Controller module that you ordered.
- This printed manual (M9037A PXIe Embedded Controller Startup Guide).
- An Automation-Ready CD with Keysight IO Libraries Suite (version 16.3 or
later). (IO Libraries was installed at the factory)
- An M9037A Product Information CD with User Guide and specifications.
Adobe Reader is required (http://www.adobe.com)
The operating system of your choice, either Microsoft Windows Embedded
Standard 7 (WES7) 32-bit or 64-bit, the latest version of Keysight IO Libraries
Suite, and all necessary driver software were installed for you at the factory.
No other drivers are required to operate the controller module. However, your
application modules may require drivers. If possible, you should connect the
M9037A to the internet and download drivers from the original source.
Alternately, you can transfer the drivers on a USB memory stick and install them
accordingly.
The most current version of Keysight IO Libraries is required prior to
installing and running any other software. The latest version can be
downloaded from: www.keysight.com/find/iosuite.
A GPIB cable is NOT supplied with the controller. Note that the
GPIB cable is a standard micro type 2 GPIB cable with standard pin
wiring and is not compatible with the M9036A Embedded
Controller GP-IB cable. It is available from Keysight as an
accessory cable, part number Y1260A.
To Next Page
Loading...
Need help?
General
