STATus:PRESet
Presets all Enable, PTR, and NTR registers.
Operation register Questionable register Presetsetting
STAT:OPER:ENAB STAT:QUES<1|2>:ENAB all defined bits are disabled
STAT:OPER:NTR STAT:QUES<1|2>:NTR all defined bits are disabled
STAT:OPER:PTR STAT:QUES<1|2>:PTR all defined bits are enabled
Parameter Typical Return
(none) (none)
Presetthe Operation and Questionable registers: STAT:PRES
STATus:QUEStionable<1|2>[:EVENt]?
Queries the event register for the Questionable Status group. This is a read-only register, which
stores (latches) all events that are passed by the Operation NTR and/or PTR filter. Reading the
Questionable Status Event register clears it.
Parameter Typical Return
(none) <bit value>
Read questionable status event register #1: STAT:QUES1?
l The value returned is the binary-weighted sum of all enabled bits in the register. For example,
with bit 2 (value 4) and bit 4 (value 16) set, the query returns +20.
l *RST has no effect on this register.
STATus:QUEStionable<1|2>:CONDition?
Queries the condition register for the Questionable Status group. This is a read-only register, which
holds the live (unlatched) operational status of the instrument. Reading the Questionable Status
Condition register does not clear it.
Parameter Typical Return
(none) <bit value>
Read questionable status condition register #1: STAT:QUES1:COND?
l The value returned is the binary-weighted sum of all enabled bits in the register. For example,
with bit 2 (value 4) and bit 4 (value 16) set, the query returns +20.
l The condition register bits reflect the current condition. If a condition goes away, the cor-
responding bit is cleared.
l *RST clears this register, other than those bits where the condition still exists after *RST.
Keysight RP7900 Series Operating and Service Guide 223
5 SCPI Programming Reference
To Next Page
Loading...
Need help?
General
