An invalid character was found in the command string.
-102 Syntax error
Invalid syntax was found in the command string. Check for blank spaces.
-103 Invalid separator
An invalid separator was found in the command string. Check for proper use of , ; :
-104 Data type error
A different data type than the one allowed was found in the command string.
-105 GET not allowed
A group execute trigger is not allowed in a command string.
-108 Parameter not allowed
More parameters were received than were expected.
-109 Missing parameter
Fewer parameters were received than were expected.
-110 Command header error
An error was detected in the header.
-111 Header separator error
A character that was not a valid header separator was found in the command string.
-112 Program mnemonic too long
The header contains more than 12 characters.
-113 Undefined header
A command was received that was not valid for this instrument.
-114 Header suffix out of range
The value of the numeric suffix is not valid.
-120 Numeric data error
Generic numeric data error.
-121 Invalid character in number
An invalid character for the data type was found in the command string.
-123 Exponent too large
The magnitude of the exponent was larger than 32000.
-124 Too many digits
5 SCPI Programming Reference
256 Keysight RP7900 Series Operating and Service Guide
To Next Page
Loading...
Need help?
General
