Keysight 33210A - Page 101

99
Chapter 3 Features and Functions
Burst Mode
3
• When the gated mode is selected, the burst count, burst period, and
trigger source are ignored (these parameters are used for the
triggered burst mode only). If a manual trigger is received, it is
ignored, and no error will be generated.
• When the gated mode is selected, you can also select the polarity of
the signal on the rear-panel Trig In connector.
• Front-Panel Operation: After enabling bursts, press the N Cycle
(triggered) or Gated softkey.
To select the polarity of the external gate signal on the Trig In
connector, press the Polarity softkey. The default polarity is POS
(true-high logic).
• Remote Interface Operation:
BURSt:MODE {TRIGgered|GATed}
• Use the following command to select the polarity of the external gate
signal on the Trig In connector. The default if NORM (true-high
logic).
BURST:GATE:POLarity {NORMal|INVerted}
33210A users guide.book Page 99 Wednesday, July 16, 2008 11:16 AM