25
Chapter 1 Quick Start
To View a Waveform Graph
4
1
To View a Waveform Graph
In the Graph Mode, you can view a graphical representation of the
current waveform parameters. The softkeys are listed in the same order
as in the normal display mode, and they perform the same functions.
However, only one label (for example, Freq or Period) is displayed for
each softkey at one time.
1 Enable the Graph Mode.
Press the key to enable the Graph Mode. The name of the
currently
selected
parameter,
shown in the upper-left corner of the display, and the
parameter’s numeric value field are both highlighted.
2 Select the desired parameter.
To select a specific parameter, note the softkey labels at the bottom of
the display.
For example
, to select period, press the Period softkey.
• As in the normal display mode, you can edit numbers using either the
numeric keypad or the knob and cursor keys.
•
Parameters which normally toggle when you press a key a second time
also toggle in the Graph Mode. However, you can see only one label
for each softkey at one time (for example, Freq or Period).
• To exit the Graph Mode, press again.
The key also serves as a key to restore front-panel control
after remote interface operations.
33210A users guide.book Page 25 Wednesday, July 16, 2008 11:16 AM
To Next Page
Loading...
