115
Chapter 3 Features and Functions
Optional Arbitrary Waveforms (Option 002)
3
7 Start the point-by-point editing process.
Press the Edit Points softkey to accept the initial waveform settings and
begin point-by-point editing. The status line at the top of the display
window shows the point number at the left, the time value of the current
point in the center, and the voltage value of the current point to the right.
8 Define the first waveform point.
Press the Voltage softkey to set the voltage level for Point #1 (this point
is fixed at a time of 0 seconds). By default, Point #1 is set equal to the
upper limit.
For this example, set the voltage level of Point #1 to 0 V.
The waveform editor performs all amplitude calculations using Vpp,
rather than Vrms or dBm.
9 Define the next waveform point.
Press the Point # softkey and then turn the knob to move to Point #2.
Press the Time softkey to set the time for the current point (this softkey
is not available for Point #1). Press the Voltage softkey to set the voltage
level for the current point.
For this example, set the time to 2 ms and the voltage level to 3.0 V.
33210A users guide.book Page 115 Wednesday, July 16, 2008 11:16 AM
To Next Page
Loading...
