121
Chapter 3 Features and Functions
System-Related Operations
3
• Front-Panel Operation: Press and then select the Store State or
Recall State softkey. To delete a stored state, select the Delete State
softkey (also removes the custom name for this memory location).
To configure the function generator to recall the factory default state
at power-on, press and then select the Pwr-On Default softkey.
To configure the function generator to recall the power-down state
when power is restored, press and select the
Pwr-On Last
softkey.
You can assign a custom name to each of the four storage locations.
• The custom name can contain up to 12 characters. The first
character
must be a letter but the remaining characters can be
letters, numbers
, or the underscore character (“ _ ”).
• To add additional characters, press the right-cursor key until the
cursor is to the right of the existing name and then turn the knob.
• To delete all characters to the right of the cursor, press the key.
• Remote Interface Operation:
*SAV {0|1|2|3|4}
State 0 is the instrument state at power down.
*RCL {0|1|2|3|4} States 1, 2, 3, and 4 are user-defined states.
To assign a custom name to a stored state to be recalled from the
front panel, send the following command. From the remote interface,
you can only recall a stored state using a number (0 through 4).
MEM:STATE:NAME 1,TEST_WFORM_1
To configure the function generator to automatically recall the power-
down state when power is restored, send the following command.
MEMory:STATe:RECall:AUTO ON
33210A users guide.book Page 121 Wednesday, July 16, 2008 11:16 AM
To Next Page
Loading...
