Keysight 33210A - Page 146

144
Chapter 3 Features and Functions
Factory Default Settings
3
Keysight 33210A Factory Default Settings
Parameters marked with a bullet (• ) are stored in non-volatile memory.
Output Configuration
Function
Frequency
Amplitude / Offset
Output Units
Output Termination
Autorange
Modulation
Carrier (AM, FM)
Carrier (PWM)
Mod. Waveform (AM)
Mod. Waveform (FM, PWM)
AM Depth
FM Deviation
PWM Width Deviation
Modulation State
Sweep
Start / Stop Frequency
Sweep Time
Sweep Mode
Sweep State
Burst
Burst Count
Burst Period
Burst Start Phase
Burst State
System-Related Operations
• Power-Down Recall
Display Mode
Error Queue
Stored States, Stored Arbs
Output State
Triggering Operations
Trigger Source
Remote Interface Configuration
• GPIB Address
• DHCP
• Auto IP
• IP Address
• Subnet Mask
• Default Gateway
• DNS Server
• Host Name
• Domain Name
Calibration
• Calibration State
Factory Setting
Sine wave
1 kHz
100 mVpp / 0.000 Vdc
Vpp
50Ω
On
Factory Setting
1 kHz Sine wave
1 kHz Pulse
100 Hz Sine wave
10 Hz Sine wave
100%
100 Hz
10 µs
Off
Factory Setting
100 Hz / 1 kHz
1 Second
Linear
Off
Factory Setting
1 Cycle
10 ms
0 degrees
Off
Factory Setting
• Disabled
On
Errors are Cleared
No Change
Off
Factory Setting
Internal (Immediate)
Factory Setting
• 10
• On
• On
• 169.254.2.20
• 255.255.0.0
• 0.0.0.0
• 0.0.0.0
• none
• none
Factory Setting
• Secured
33210A users guide.book Page 144 Wednesday, July 16, 2008 11:16 AM