Keysight 33210A - Page 148

146
4
SCPI
Remote Interface Reference
• SCPI Command Summary, on page 147
• Simplified Programming Overview, on page 160
• Using the APPLy Command, on page 162
• Output Configuration Commands, on page 171
• Pulse Configuration Commands, on page 184
• Amplitude Modulation (AM) Commands, on page 189
• Frequency Modulation (FM) Commands, on page 193
• Pulse Width Modulation (PWM) Commands, on page 203
• Frequency Sweep Commands, on page 203
• Burst Mode Commands, on page 211
• Triggering Commands, on page 219
• ArbitraryWaveformCommands(Option002), on page 222
• State Storage Commands, on page 233
• System-Related Commands, on page 237
• Interface Configuration Commands, on page 242
• Phase-Lock Commands (Option 001 Only), on page 247
• The SCPI Status System, on page 249
• Status Reporting Commands, on page 259
• Calibration Commands, on page 263
• An Introduction to the SCPI Language, on page 265
• Using Device Clear, on page 270
SCPI
SCPI
Throughout this manual “default” states and values are identified. These
are the power-on default states provided you have not enabled the
power-down recall mode (see “Instrument State Storage” in chapter 3).
If you are a first-time user of the SCPI language, please refer to these sections to become
familiar with the language before attempting to program the function generator.
33210A users guide.book Page 146 Wednesday, July 16, 2008 11:16 AM